top of page

I'm finally getting a 3D printer!

It has been a little while since my last post and wanted to give an update on current designs. Well....not a lot has been done since I finished up the wallet as most of my time has been on wallets, pry bars, and hanks. I just shipped out all open orders of pry bars and have a little time to focus on the next product.

To help that, I finally pulled the trigger on my own 3D printer. Before I would outsource to friends to help out and this should dramatically decrease design and development time. I also hope this allows me to make a few extra prototypes to get some feedback from the community.

Stay tuned for more updates as I nail down the next product design and as always feel free to reach out with any suggestions or ideas.

21 views0 comments

Recent Posts

See All


bottom of page